testing fan on early 2015 13 macbook pro

Testing fan on early 2015 13 macbook pro how to#
Testing fan on early 2015 13 macbook pro pro#

With macOS 10.13, otherwise known as High Sierra, Apple introduced an ambitious EFI update.

If the fan doesn’t start spinning after 10 seconds, then reattempt the bridge between the power-on pads.

Maintain the bridge for a maximum of three seconds.

Use the paper clip or flat head screwdriver to bridge the connection with the 2 power-on pads.

Locate the power-on pads using the reference pictures below.

Now that the keyboard cable is disconnected, plug the battery in again.

This step is very important! If you leave the keyboard plugged into the logic board, the power pads won’t work.

Disconnect the keyboard cable from your logic board.

Connecting/disconnecting other cables while power is connected can cause damage.

Disconnect the power adapter and battery.

Don’t forget to protect your computer from ESD discharge by grounding yourself ahead of time.

A paperclip with electrical tape on the area you will hold (to act as an insulator) or a flat head screwdriver.

The proper screwdriver to remove bottom case screws for your particular model.

Diagnosing Apple hardware issues is a simple process of elimination, and bypassing the keyboard allows you to at least rule out one component. There are probably quite a few ways you could damage this connection if you’re creative enough, but we typically find that either corrosion from a liquid spill damaged the logic board’s keyboard connector, or the keyboard flex cable was damaged from repeatedly attempting to insert the cable. The power button is connected to the logic board via the same 30-pin cable as the rest of the keyboard, and of those 30 pins, only two are necessary for the signal to travel from the power button to the logic board. There are lots of reasons why your MacBook Air might not turn on, and this procedure only rules out a single, but very common root cause.

Testing fan on early 2015 13 macbook pro pro#

We’ve talked about this topic before on the Beetstech Blog last time covering the MacBook Pro Unibody product line. If you’re looking for power on pad info for the MacBook Pro Unibody models follow this link.

Testing fan on early 2015 13 macbook pro how to#

Apple was generous enough to design an integrated method for bypassing the power button on all MacBook logic boards. Below I’ll show you how to use the power pads, as well as provide high-res reference photos of the locations of these power pads on each individual release of the MacBook Air. If your MacBook won’t power on, there’s an easy way to determine if the problem lies with the power button or with another component in the laptop. Is it the power button? Logic board? Something else? Whatever you call them, there are two bits of metal on your MacBook logic board that can force your laptop to boot up, even if the power button won’t do the trick. They go by “jumper pads”, “short-circuit pads”, “power pads”, and “power-on pads”.